Eagle superhero guy 3D printed factory cosplay costume set in ANTIQUE gold: buckle/shoulder guards/boots

factory Eagle superhero guy costume/cosplay set, 3D printed in antique gold PLA. Included 2 shoulder guards, 1 belt buckle & 2 boot emblems.

THE EAGLE SHOULDER GUARDS (PAULDRONS)
Printed in one piece in antique gold PLA. The images show how they looked directly off the print bed. No sanding was required (you could sand if you wish & apply a layer of primer & paint). Though print lines are barely visible & sanding really isn't needed in my opinion.I've installed a small loop on the inside for easier attachment to a costume.
Size is approximately 183mm wide x 144mm high 74mm depth.

THE EAGLE BELT BUCKLE
Printed as per shoulder guards. Has a very small slit on the back. Where a piece of material could be threaded through, which then could be sewn or glued to a costume, or you could directly hot glue the buckle.
Size is approximately 80mm wide x 78mm high 19mm depth.

THE EAGLE BOOTS EMBLEMS
Printed as per the previous items.
Size is approximately 76mm wide x 90mm high. Slightly curved.

Each set takes approximately 50 hours to print.